Code: 981
Description: Belt Up/Down Sensor Error
Remedy: 1 Are connectors CN409 and CN407 on the sensor board connected properly? Go to step 2. Plug the connectors in securely. 2 Are connectors CN26 and CN29 on the printer controller board connected properly? Go to step 3. Plug the connector in securely. 3 Remove the transfer belt. Verify the belt up/down sensor actuator flag is properly installed, not broken, and in the proper position. Make sure the sensor is fully snapped in place and that the sensor connector is fully seated. Are these items correct? Go to step 4. If the sensor is out of position or disconnected, properly install the sensor and securely connect the sensor connector. If the sensor actuator flag is broken, replace the belt up/down changing shaft. 4 Clean the belt up/down sensor. Does this fix the problem? Problem solved. Go to step 5. 5 Test the sensor. While actuating the sensor, does the voltage fluctuate between 0 V and +5 V between pins 7 and 8 of connector CN29 on the printer controller board? Replace the belt up/down clutch. Go to step 6. Replace the belt up/down sensor. 6 Did replacing the belt up/ down clutch fix the problem? Problem solved. Replace the printer controller board.