Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E010 — Toshiba e-Studio 6570C

Code: E010

Description: Jam not reaching the fuser transport sensor The paper which has passed through the fuser unit does not reach the fuser transport sensor.
Causes: Fuser transport sensor LGC board ADU board PFC board Fuser unit
Remedy: ADU board • Connector check (CN491, CN497) • Board check Fuser transport sensor • Sensor check (Perform the input check: 03-[ALL]OFF/[2]/[C], 03- [COPY]ON/[5]/[F]) • Connector check • Harness check LGC board • Connector check (CN309) • Harness check • Board check Fuser unit • Check the gap between the separation plate and the fuser belt. (Refer to “6.7.4 Gap adjustment for separation plate”.) • Paper transport check Drive unit, Rollers • Gear check • Roller check Leading edge margin Adjust the margin with 05-4402 (Leading edge position adjustment) to “Color: 5.5 mm”. (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • Black solid image on 10 mm of the leading edge Refer to “6.1.1 Image Related Adjustment”. 2nd transfer bias offset Change the 2nd transfer bias offset value as shown below and then check if there are still jams. Change the default value 5 of each code below to 6 or 7. Color: 05-2934 Subcode: 0, 7 Color: 05-2935 Subcode: 0, 7 Black: 05-2936 Subcode: 0, 7 Black: 05-2937 Subcode: 0, 7 Change of the 2nd transfer bias If the leading edge of paper clings to the 2nd transfer roller and causes paper jamming, change the 2nd transfer roller bias correction factor of the leading/trailing edge of the paper. (The larger the value, the smaller the transfer voltage of the leading/trailing edge of the paper.) Codes to be changed (Initial value of the transfer bias of the leading/trailing edge of the paper: 0) • Color mode print (top side): 05-2938-* • Color mode print (back side): 05-2939-* • Black mode print (top side): 05-2940-* • Black mode print (back side): 05-2941-* Sub codes:* → Plain paper: 0, Recycled paper: 7 Notes: After these codes are changed, perform solid duplexprinting and check that there is no faint or void image on the leading/trailing edge of the paper. PFC board • Connector check (CN500, CN511) • Harness check • Board check

← Xem tất cả mã lỗi Toshiba e-Studio 6570C

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie