Code: 01A
Description: Power Failure
Causes:
Remedy: 1. Ensure the supply voltage is correct. If possible, connect the machine to a known good power supply. If the original power supply is faulty, inform the customer. 2. Disconnect the power cord from the power outlet and the machine. Check the continuity of the power cord. If necessary, install a new power cord. 3. Disconnect CON1 on the SMPS. Check for AC supply voltage between pins 1 and 2 on the connector. If necessary, install a new SMPS assembly. 4. Check the fuse F01 on the SMPS. If necessary, install a new SMPS assembly. NOTE: Fuse F01 is not spared. 5. Remove the fuser. Check for continuity across the fuser heat lamp. Install new components as necessary and . NOTE: A cold fuser heat roll has a resistance of approximately 9 ohms (220V/240V) or 1.6 ohms (110V). 6. Switch off the power to the machine. Disconnect all connectors on the Connection PWB except CN5 and CN6. 7. Switch on the power to the machine. If the machine switches on, perform step 8. If the machine fails to switch on, go to step 9. 8. Sequentially reconnect each connector onto the Connection PWB. If the faulty circuit is identified, repair the wiring or install components as necessary. If the machine still fails to switch on, install a new connection PWB . 9. Reconnect all connectors onto the Connection PWB. Disconnect all connectors from the Main PWB except CN26 and CN31. 10. Switch on the power to the machine. If the machine switches on, perform step 11. If the machine fails to switch on, go to step 12. 11. Sequentially reconnect each connector onto the Main PWB. If the faulty circuit is identified, repair the wiring or install components as necessary. If the machine still fails to switch on perform OF7 Main PWB Check RAP. 12. Reconnect all connectors onto the Main PWB. Disconnect CN4 from the HVPS, refer to REP 1.2. 13. Re-install the HVPS. Switch on the machine. If the machine switches on, check the wiring between the HVPS and the tray 1 paper empty sensor. Install new components as necessary and . If the machine fails to switch on, install a new HVPS . 14. If the fault is still present: a. Install new components as necessary: • SMPS assembly . • Connection PWB . • HVPS . b. Perform OF7 Main PWB Check RAP.