Code: 05-100
Description: DADF Jam 1
Causes: The lead edge of the document failed to actuate the scan sensor within the correct time after registration solenoid actuation.
Remedy: 1. Open the DADF door assembly . Remove all jammed paper. 2. Check the document path for damage or obstructions. 3. Check that the following components are clean and rotate freely: • Registration roll . • Registration roll idlers . 4. Remove the transport assembly upper cover . 5. Check that the DADF scan sensor actuator moves freely and is not damaged. 6. Enter dC330 code 05-140. Check the scan sensor (Q05-140) . If necessary, install a scan sensor. 7. Check the wiring between the DADF scan sensor and CN1 on the DADF PWB. 8. Remove the DADF rear cover . Enter dC330 code 05-200. Check that the DADF scan motor runs. 9. Check the wiring between the DADF scan motor and CN9 on the DADF PWB. 10. Open the DADF door assembly . Manually actuate the DADF door open sensor . While the DADF scan motor runs, stack the code 05-310 to energize the DADF registration solenoid (SOL05-310). Check that the registration roll rotates. 11. Check the wiring between the DADF registration solenoid and CN8 on the DADF PWB. 12. If necessary, install new components: • DADF PWB . • DADF scan motor . • DADF registration solenoid . • DADF drive assembly . • Document transport assembly .