Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 08-500 — Xerox Phaser 3635 MFP

Code: 08-500

Description: Jam 2
Causes: The trail edge of the document failed to deactuate the exit sensor within the correct time after registration.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Open the rear door. Release the fuser pressure rolls, then remove all jammed paper. 3. Remove the fuser module . Check the paper path for damage or obstructions. 4. Open the fuser door . Check the following, install new components as necessary: a. The fuser exit sensor actuator moves freely and is not damaged. b. The fuser heat roll , pressure roll 1 and pressure roll 2 are clean and rotate freely. c. The fuser exit roll and idlers are clean and rotate freely. d. The fuser stripper fingers . 5. Remove the exit drive assembly . Check the following components are clean and rotate freely: a. Exit roll . b. Exit roll idlers and . c. Transport roll . Install new components as necessary and . 6. Enter dC330 code 08-600. Check the fuser exit sensor (Q08-600). If necessary, install a new HVPS . NOTE: The fuser exit sensor is mounted on the HVPS. 7. Reinstall the fuser and the exit motor. Enter dC330 code 04-200. Check that the exit motor (MOT04-200) , runs and drives the fuser rolls , and exit roll . 8. Check the wiring between the exit motor and CN2 on the Connection PWB. Install new components as necessary and . 9. Install new components as necessary: • Duplex guide . • Connection PWB .

← Xem tất cả mã lỗi Xerox Phaser 3635 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie