Code: E1-1
Description: Paper Size Jam - E1-1 Regi Area Jam Paper did not pass the Registration Sensor located behind Door A, within the specified time.
Causes: • Registration Sensor • Registration Clutch • Take Away Roller • Engine Control Board
Remedy: 1 Check paper position at Door A or B. Does the paper touch the Registration Sensor or Feeder’s Pre-Feed Sensor? Remove the paper. Go to Step 2. 2 Check the Take Away Roller. Open Door A. Is the Take Away Roller worn or contaminated with paper dust? Clean or replace the Take Away Roller. Go to Step 3. 3 Test the Registration Sensor. 1. Open Door A. 2. Run the Service Diagnostics Registration Sensor test. Does the sensor change state? Go to Step 7. Go to Step 4. 4 Check the Registration Sensor connection. Are P/J104 and P/J403B connected? Go to Step 5. Connect the sensor. 5 Check continuity between the Registration Sensor and Engine Control Board. Is there continuity on each wire between P/ J104 <=> P/J403? Go to Step 6. Repair the wiring. 6 Check for +5 V at the Registration Sensor. Is there +5 V across the sensor connector’s P/J104-1 <=> ground? Replace the Registration Sensor. Replace the Engine Control Board. 7 Test the Registration Clutch operation.Run the Service Diagnostics Registration Clutch test. Does the clutch operate properly? Replace the Engine Control Board (page 8-89). Go to Step 8. 8 Check the Registration Clutch connection. Are P/J215 and P/J403B connected? Go to Step 9. Connect P/J215 and P/J403B. 9 Check continuity between the Registration Clutch and Engine Control Board. Is there continuity on each wire between P/ J215 <=> P/J403? Go to Step 10. Repair the wiring. 10 Check for +24 V to the Registration Clutch. Is there +24 V across P215-2 (+) <=> ground? Go to Step 11. Replace the Engine Control Board. 11 Check Registration Clutch resistance. Replace the Engine Control Board. Replace Registration Clutch.