Code: E1-2
Description: Jam at A - E1-2 Regi Area Jam Paper did not activate the Fuser Exit Sensor, located behind Door A, within the specified time following activation of the Registration Clutch. NOTE: If the printer exhibits first sheet jams following power On or Power Saver mode and reports Jam Code E1-2, check actuator motion on the Fuser Exit Sensor Assembly. Accumulations of toner, when cool, can bind the actuator on earlier versions of the assembl
Causes: • Fuser Exit Sensor • Registration Clutch • Take Away Roller • Exit PWB • Engine Control Board
Remedy: 1 Check paper position behind Door A. Does the paper touch the Fuser Exit Sensor? Remove the paper. Go to Step 2. 2 Check the Take Away Roller. Is the Take Away Roller worn or contaminated with paper dust? Clean or replace the Take Away Roller. Go to Step 3. 3 Test the Fuser Exit Sensor. 1. Open Door A. 2. Run the Service Diagnostics Fuser Exit Sensor test. Does the sensor change state? Go to Step 7. Go to Step 4. 4 Check the Fuser Exit Sensor connection. Are P/J125 and P/J410 connected? Go to Step 5. Connect the sensor. 5 Check continuity between the Fuser Exit Sensor and Engine Control Board. Is there continuity on each wire between P/ J125 <=> P/J410? Go to Step 6. Repair the wiring. 6 Check for +5 V at the Fuser Exit Sensor. Is there +5 V across the sensor connector’s P/J125-3 <=> ground? Replace the Fuser Exit Sensor. Replace the Engine Control Board 7 Test the Registration Clutch operation. Run the Service Diagnostics Registration Clutch test. Does the clutch operate properly? Replace the Engine Control Board. Go to Step 8. 8 Check the Registration Clutch connection. Are P/J215 and P/J403B connected? Go to Step 9. Connect P/J215 and P/J403B. 9 Check continuity between the Registration Clutch and Engine Control Board. Is there continuity on each wire between P/ J215 <=> P/J403B? Go to Step 10. Repair the wiring. 10 Check for +24 V to the Registration Clutch. Is there +24 V across P215-2 (+) <=> ground? Go to Step 11. Replace the Engine Control Board. 11 Check Registration Clutch resistance. Is the resistance between J215-1 and J215- 2 approximately 240 ohms? Replace the Engine Control Board. Replace Registration Clutch.