Code: E4-6
Description: Jam at E - E4-6 Exit 2 Area Jam Paper remains at the Exit 2 Exit Sensor located behind Door E.
Causes: • Exit 2 Exit Sensor • Exit PWB • Engine Control Board • LVPS
Remedy: 1 Check paper position at Door A. Is paper touching the Fuser Exit Sensor? Remove the paper. Go to Step 2. 2 Test the Exit Sensor. Run the Service Diagnostics Exit Sensor test. Does the sensor change state? Replace the Engine Control Board. Go to Step 3. 3 Check the Exit Sensor connection. Are P/J112, P/J606B and P/J434 connected? Go to Step 4. Connect the sensor. 4 Check continuity between the Exit Sensor and Exit PWB. Is there continuity on each wire between P/ J112<=> P/J434? Go to Step 5. Repair the wiring. 5 Check for +5 V at the Exit Sensor. Is there +5 V across the sensor connector’s P/J112-3 <=> ground? Replace the Exit Sensor. Go to Step 6. 6 Check the connection between the Exit PWB and Engine Control Board. Are P/J431 and P/J421 connected? Go to Step 7. Connect P/J431 and P/J421. 7 Check continuity between the Exit PWB and Engine Control Board. Is there continuity on each wire between P/ J431 <=> P/J421? Go to Step 8. Repair the wiring. 8 Check the connection between Exit PWB and LVPS. Are P/J430 and P/J526 connected? Go to Step 9. Connect P/J430 and P/J526. 9 Check continuity between the Exit PWB and LVPS. Is there continuity on each wire between P/ J430 <=> P/J526? Go to Step 10. Repair the wiring. 10 Check for +24 V to the Exit PWB. Is there +24 V across P/J430-1 (+) <=> ground? Replace the Exit PWB. Replace the LVPS.