Code: 010-317
Description: Insert Fuser 010-317 The printer does not detect the Fuser.
Causes: • Fuser, PL6.1.1 • Fuser Harness, PL6.1.2 • MCU Board, PL8.2.13
Remedy: 1 Reseat the Fuser and cycle system power. Does the error persist? Go to step 2. Complete 2 Check the connections between the MCU Board P/J17 and Fuser P/J171. Are the connectors secure? Go to step 3. Secure the connectors. 3 Check the Fuser harness continuity. 1. Remove the Fuser. 2. Disconnect J17 from the MCU Board. Is the harness damaged? NOTE P171 is attached to the frame. Repair the harness. Go to step 4. 4 Check Fuser temperature sensor resistance. 1. Remove the Fuser. 2. Check resistance across these Fuser pins: • J171-5pin <=> J171-4pin • J171-6pin <=> J171-8pin • J171-6pin <=> J171-7pin Is there measurable resistance? (Resistance is 7 K Ohm at 180 degrees C). Replace the MCU Board. Replace the Fuser.