Code: 092-310
Description: CTD Sensor Error 092-310 Caution Do not run the toner motors for more than a few seconds. The ADC Sensor has detected a density error for the indicated color.
Causes: • Left Side Harness, PL3.1.18 • Imaging Unit, PL4.1.21 • Dispense Assembly, PL5.1.1 • Toner Cartridges, PL5.1.21~24 • Toner Motor harness, PL5.1.25 • Transfer Belt, PL6.1.7 • MCU Board, PL8.2.13
Remedy: 1 Check the Transfer Belt installation. Is the Transfer Belt correctly installed? Go to step 3. Correct the installation. Go to step 2. 2 Does the error persist? Go to step 3. Complete. 3 Test the Toner Motor: Engine Diag > Motor Test > CMYK Toner Motor for the affected color. Does the motor rotate? Go to step 4. Go to step 5. 4 Check the Dispense Assembly gear for the indicated color. Is the gear damaged or excessively worn? Replace the Dispense Assembly. Go to step 5. 5 Check Left Side Harness continuity. Disconnect P/J28 from the MCU Board and P/J281 to the Transfer Belt. Is the harness damaged? Repair or replace the harness. Go to step 6. 6 Check MCU Board connectors P/J18 and toner motor connections: • P/J181(Y) • P/J182(M) • P/J191(C) • P/J192(K) Are the connectors secure? Go to step 7. Reconnect the connectors. 7 Check Toner Motor harness continuity. Disconnect P/J18 from the MCU Board and the connection to the indicated toner motor. Is the harness damaged? Repair or replace the harness. Go to step 8. 8 Check for +24 V at J18 or J19 on the MCU Board. Is +24 V available at • J18-3 (Y) • J18-8 (M) • J19-4 (C) • J19-9 (K) when the Interlock Switch is closed? Replace the Dispense Assembly. Replace the MCU Board. 9 Replace the indicated Toner Cartridge. Does the error persist? Go to step 10. Complete. 10 Replace the Imaging Unit. Does the error persist? Replace the Transfer Belt. Complete.