Code: 010-397
Description: Fuser Error The Fuser temperature regulation has failed. The NC sensor circuit in the MCU is defective. Warning The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes for the Fuser to cool before removing the Fuser.
Causes: • Fuser, PL6.1.10 • Fuser Harness, PL6.1.11 • LVPS, PL9.1.4 • MCU Board, PL9.1.20 • Top LV Harness, PL10.1.16
Remedy: 1 1. Check the Fuser for correct installation. 2. Is the Fuser correctly installed? Go to step 2. Reseat the Fuser. Go to step 2. 2 Does the error still occur? Go to step 3. Complete. 3 1. Check the wiring harness connectors P/ J13, P/J17, P/J171, P/J47, and P/J501. 2. Are the connectors securely connected? Go to step 4. Reconnect the connectors. Go to step 4. 4 Check the Fuser Harness for continuity. 1. Disconnect P/J17 from the MCU Board and P/J171 from the Fuser. 2. Check continuity between P/J17 <=> P/ J171. Go to step 5. Replace the Fuser Harness. 5 Check the Top LV Harness for continuity. 1. Disconnect P/J 47 and P/J501 from the LVPS. 2. Disconnect P/J13 from the MCU Board. 3. Check continuity between: • P/J47 <=> P/J171 • P/J501 <=> P/J13 Go to step 6. Replace the Top LV Harness. 6 1. Replace the Fuser. 2. Does the error still occur? Go to step 7. Complete. 7 1. Replace the LVPS. 2. Does the error still occur? Replace the MCU Board. Complete.