Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-958 — Xerox Phaser 6280

Code: 024-958

Description: Load Tray 1 (MPT) (Paper Size Mismatch) The paper size mismatch is detected in Tray 1 (MPT).
Causes: • Tray 1 (MPT) Cover, PL2.1.24 • Registration Sensor, PL3.2.30 • Registration Sensor Harness, PL3.2.37 • MCU Board, PL9.1.20 • Right Side Harness, PL10.1.15 • Tray 1 (MPT) Feed Roll, PL3.1.10
Remedy: 1 1. Check the paper size. 2. Does the paper size meet specifications? Go to step 2. Replace the paper with the correct specifications. 2 1. Check the paper size setting. 2. Does the paper match with the settings in the Control Panel? Go to step 4. Correct the paper settings in the Control Panel. Go to step 3. 3 Does the error still occur? Go to step 4. Complete. 4 1. Perform the Registration Sensor test: Service Mode > Engine Diag > Sensor Test > Regi Sensor. 2. Does the number on the Control Panel increase by 1 when the Actuator of the Registration Sensor is activated? Go to step 10. Go to step 5. 5 1. Check the wiring harness connectors P/J29, P/J292, and P/ J2922 between the MCU Board and the Registration Sensor. 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. 6 Check the Registration Sensor Harness for continuity. 1. Disconnect P/J292 from the Right Side Harness and P/J2922 from the Regi Sensor. 2. Check continuity between P/J292 <=> P/J2922. Go to step 7. Replace the Registration Sensor Harness. 7 Check the Right Side Harness for continuity. 1. Disconnect P/J29 from the MCU Board and P/J292 from the Regi Sensor Harness. 2. Check continuity between P/J29 <=> P/J292. Go to step 8. Replace the Right Side Harness. 8 Check the Registration Sensor for continuity. 1. Disconnect P/J29 from the MCU Board. 2. Is there +3.3 V across ground <=> J29-8 pin? Go to step 9. Replace the MCU Board. 9 Check the Registration Sensor signal. 1. Measure the voltage across ground <=> J29-10 pin on the MCU Board. 2. Does the voltage change when the Actuator of the Registration Sensor is activated? Replace the MCU Board. Replace the Registration Sensor. 10 1. Check the Rollers for rotation. 2. Does the Rollers rotate smoothly? Replace the MCU Board. Replace the defective Rollers. • Tray 1 (MPT) Feed Roll

← Xem tất cả mã lỗi Xerox Phaser 6280

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie