Code: 042-325-01
Description: Main Motor Error The Main Motor has failed.
Causes: • Main Drive Assembly, PL8.1.2 • MCU Board, PL9.1.20 • Right Side Harness, PL10.1.15
Remedy: 1 1. Check the detailed error code (press the Up and Down buttons simultaneously). 2. Does code g00h display on the Control Panel? Go to step 2. 2 1. Check the Transfer Unit, Fuser, and Black Print Cartridge for correct installation. 2. Are the parts seated correctly? Go to step 3. Reseat the following items: • Transfer Unit • Fuser Assembly • Black Print Cartridge • Go to step 2. 3 Does the error still occur? Go to step 4. Complete. 4 1. Check the wiring harness connectors P/J22 and P/J222 between the MCU Board and the Main Drive Assembly. 2. Are the connectors securely connected? Go to step 6. Reconnect the connectors. Go to step 5. 5 Does the error still occur? Go to step 6. Complete. 6 1. Perform the Main Motor test: Service Mode > Engine Diag > Motor Test > Main Motor. During the test, close the Front Cover. 2. Does the Motor operate properly? Replace the MCU Board. Go to step 7. 7 1. Check the Main Drive Assembly for correct installation. 2. Is the Main Drive Assembly securely installed? Go to step 8. Reseat the Main Drive Assembly. Go to step 8. 8 Does the error still occur? Go to step 9. Complete. 9 Check the Right Side Harness for continuity. 1. Disconnect P/J22 from the MCU Board and P/J222 from the Main Drive Assembly. 2. Check continuity between P/J22 <=> P/J222. Go to step 10. Replace the Right Side Harness. 10 Check the Main Drive Assembly signal. 1. Disconnect P/J22 from the MCU Board. 2. Are there +24 V across ground <=> J22-B2/J22-B4 pin when the Interlock Switch is activated? Replace the Main Drive Assembly. Replace the MCU Board.