Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-325-03 — Xerox Phaser 6280

Code: 042-325-03

Description: Tray 2 (PH) Motor Error The Tray 2 Motor has failed.
Causes: • Feeder Assembly, PL3.2.1 • PH Drive Assembly, PL8.1.7 • MCU Board, PL9.1.20 • Right Side Harness, PL10.1.15
Remedy: 1 1. Check the detailed error code (press the Up and Down buttons simultaneously). 2. Does code g03h display on the Control Panel? Go to step 2.    2 1. Check the Rubber Registration Roller for rotation. 2. Does the Roller rotate smoothly? Go to step 3. Replace the Feeder Assembly. 3 1. Check the wiring harness connectors P/J25 and P/J251 between the MCU Board and the PH Drive Assembly. 2. Are the connectors securely connected? Go to step 4. Reconnect the connectors. Go to step 4. 4 1. Perform the Tray 2 Motor test: Service Mode > Engine Diag > Motor Test > Tray 2 Motor. During the test, close the Front Cover. 2. Does the Motor operate properly? Replace the MCU Board. Go to step 5. 5 1. Check the PH Drive Assembly for correct installation. 2. Is the PH Drive Assembly correctly installed? Go to step 6. Reseat the PH Drive Assembly. Go to step 6. 6 Does the error still occur? Go to step 7. Complete. 7 Check the Right Side Harness for continuity. 1. Disconnect P/J25 from the MCU Board and P/J251 from the PH Drive Assembly. 2. Check continuity between P/J25 <=> P/J251. Go to step 8. Replace the Right Side Harness. 8 Check the PH Drive Assembly signal. 1. Disconnect P/J25 from the MCU Board. 2. Are there +24 V across ground <=> J25-1/J25-2 pin when the Interlock Switch is activated? Replace the PH Drive Assembly. Replace the MCU Board.

← Xem tất cả mã lỗi Xerox Phaser 6280

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie