Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 042-372 — Xerox Phaser 6280

Code: 042-372

Description: Deve Mode Error The Deve Mode (K Mode) change failure has been detected.
Causes: • K Drive Assembly, PL8.1.10 • MCU Board, PL9.1.20
Remedy: 1 1. Perform the K Mode Solenoid test: Service Mode > Engine Diag > Motor Test > K Mode Clutch On. During the test, close the Front Cover. 2. Does the K Mode Solenoid make a clicking sound? Go to step 2. Go to step 8. 2 1. Check the K Drive Assembly for correct installation. Reseat the K Drive Assembly. 2. Does the error still occur? Go to step 3. Complete. 3 1. Check the wiring harness connectors P/J20 and P/J201 between the MCU Board and the K Mode Sensor. 2. Are the connectors securely connected? Go to step 5. Reconnect the connectors. Go to step 4. 4 Does the error still occur? Go to step 5. Complete. 5 Check the Regi Clutch Sensor Harness for continuity. 1. Disconnect P/J20 from the MCU Board and P/J201 from the K Mode Sensor. 2. Check continuity between P/J20 <=> P/J201. Go to step 6. Replace the K Drive Assembly. 6 Check the K Mode Sensor signal. 1. Disconnect P/J20 from the MCU Board. 2. Is there +3.3 V across ground <=> J20-1 pin on the MCU Board? Go to step 7. Replace the MCU Board. 7 Check the K Mode Sensor for operation. Note: Be sure to keep P/J201 and P/ J24 connectors connected. 1. Remove the K Drive Assembly. 2. Perform the K Mode Sensor test: Service Mode > Engine Diag > Sensor Test > K Mode SNR. During the test, close the Front Cover. 3. Does the voltage change when a piece of paper is inserted into the gap of the K Mode Sensor? Replace the MCU Board. Replace the K Drive Assembly. 8 1. Check the wiring harness connectors P/J24 and P/J241 between the MCU Board and the K Mode Solenoid. 2. Are the connectors securely connected? Go to step 10. Reconnect the connectors. Go to step 9. 9 Does the error still occur? Go to step 10. Complete. 10 Check the K Mode Solenoid signal. 1. Disconnect P/J24 from the MCU Board. 2. Is there +24 V across ground <=> J24-1 pin on the MCU Board when the Interlock Switch is activated? Go to step 11. Replace the MCU Board. 11 Check the K Mode Solenoid for resistance. 1. Disconnect P/J24 from the MCU Board. 2. Is the resistance across J24-1 and J24-2 about 80 to 110 ohm? Replace the MCU Board. Replace the K Drive Assembly.

← Xem tất cả mã lỗi Xerox Phaser 6280

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie