Code: 04-500
Description: Main Drive (BLDC) Motor Start Fault The Main Drive (BLDC) Motor did not start within the specified time after the ready signal was sent.
Remedy: Enter Diagnostic Mode. Press the <Menu> button, the <#> button, then using the keypad select: [1934, Diagnostics, Machine Test, EDC Mode, DC330 Component Control, 100 Motor] to start the motor. The motor rotates. Y↓N→Remove the Right Cover and check the motor connector on the Main PWB. The connector on the Main PWB is connected correctly. Y↓N→Reconnect the motor connector. Remove the Duplex paper Guide. Check the motor connector. The connector is OK. Y↓N→Reconnect the connector The Imaging Unit Drive coupler may have overloaded. Remove the Print Cartridge and rotate the Imaging Unit coupler. The Imaging Unit coupler rotates freely. Y↓N→Replace the Imaging Unit. The Main Drive Motor or the Main PWB is defective. Perform the following: • Replace the Main Drive Motor PL 4.1. If problem persists, replace the Main PWB, PL 1.1.