Code: C1-2
Description: Tray1 Regi SNR on JAM. Timeout between Tray1 Feed Sensor ON and IOT Registration Sensor ON.
Remedy: I/O Diagnostic Codes • [08-07] Tray1 Feed Sensor • [08-05] IOT Registration Sensor • [08-10] IOT Registration Clutch
Check Items: • Take Away Roll 1 dirty, contaminated with paper dust, worn, or faulty • Tray1 Feed Sensor dirty and Sensor Actuator deformed or damaged • Paper damaged, not within specification, or not loaded correctly • Foreign matter, burrs, or paper in the paper path • Drive gear worn or damaged • IOT Registration Clutch faulty • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor (PL 2.5) . – Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and LVPS J501-6 ( P/J501) – Wire between Tray 1 Feed Sensor J158-2 and LVPS J501-7 – Wire between Tray 1 Feed Sensor J158-1 and LVPS J501-8 • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the IOT Registration Sensor (PL 2.9). - Wire between IOT Registration Sensor J156-3 ( P/J156) and LVPS J503-1 ( P/J503) - Wire between IOT Registration Sensor J156-2 and LVPS J503-2 - Wire between IOT Registration Sensor J156-1 and LVPS J503-3 • Replace the IOT Registration Clutch (PL 2.9) and the AIOC PWB (PL 8.1) in that order.
Check Items: • Take Away Roll 1 dirty, contaminated with paper dust, worn, or faulty • Tray1 Feed Sensor dirty and Sensor Actuator deformed or damaged • Paper damaged, not within specification, or not loaded correctly • Foreign matter, burrs, or paper in the paper path • Drive gear worn or damaged • IOT Registration Clutch faulty • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor (PL 2.5) . – Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and LVPS J501-6 ( P/J501) – Wire between Tray 1 Feed Sensor J158-2 and LVPS J501-7 – Wire between Tray 1 Feed Sensor J158-1 and LVPS J501-8 • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the IOT Registration Sensor (PL 2.9). - Wire between IOT Registration Sensor J156-3 ( P/J156) and LVPS J503-1 ( P/J503) - Wire between IOT Registration Sensor J156-2 and LVPS J503-2 - Wire between IOT Registration Sensor J156-1 and LVPS J503-3 • Replace the IOT Registration Clutch (PL 2.9) and the AIOC PWB (PL 8.1) in that order.