Code: C2-2
Description: Tray1 F/O#1 SNR on JAM from STM feed. Timeout between STM Feed Out Sensor ON and Tray 1 Feed Out Sensor ON.
Remedy: I/O Diagnostic Codes • [08-06] STM Feed Sensor • [08-07] Tray1 Feed Sensor • [08-11] STM Feed Clutch • [08-13] STM Feed Motor
Check Items: • Take Away Roll 2 dirty, contaminated with paper dust, worn, or faulty • STM Feed Sensor dirty and Sensor Actuator deformed or damaged • Paper damaged, not within specification, or not loaded correctly • Foreign matter, burrs, or paper in the paper path • Drive gear worn or damaged • STM Feed Clutch faulty • STM Feed Motor faulty • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the STM Feed Sensor (PL 11.5) . – Wire between STM Feed Sensor J172-3 ( P/J172) and STM PWB J542-6 ( P/J542) – Wire between STM Feed Sensor J172-2 and STM PWB J542-7 – Wire between STM Feed Sensor J172-1 and STM PWB J542-8 • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor (PL 2.5) . – Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and STM PWB J501-6 ( P/J501) – Wire between Tray 1 Feed Sensor J158-2 and STM PWB J501-7 – Wire between Tray 1 Feed Sensor J158-1 and STM PWB J501-8 • Replace the STM Feed Clutch (PL 11.6) , the STM Feed Motor (PL 11.6) , and the STM PWB (PL 11.5) in that order.
Check Items: • Take Away Roll 2 dirty, contaminated with paper dust, worn, or faulty • STM Feed Sensor dirty and Sensor Actuator deformed or damaged • Paper damaged, not within specification, or not loaded correctly • Foreign matter, burrs, or paper in the paper path • Drive gear worn or damaged • STM Feed Clutch faulty • STM Feed Motor faulty • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the STM Feed Sensor (PL 11.5) . – Wire between STM Feed Sensor J172-3 ( P/J172) and STM PWB J542-6 ( P/J542) – Wire between STM Feed Sensor J172-2 and STM PWB J542-7 – Wire between STM Feed Sensor J172-1 and STM PWB J542-8 • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Tray 1 Feed Sensor (PL 2.5) . – Wire between Tray 1 Feed Sensor J158-3 ( P/J158) and STM PWB J501-6 ( P/J501) – Wire between Tray 1 Feed Sensor J158-2 and STM PWB J501-7 – Wire between Tray 1 Feed Sensor J158-1 and STM PWB J501-8 • Replace the STM Feed Clutch (PL 11.6) , the STM Feed Motor (PL 11.6) , and the STM PWB (PL 11.5) in that order.