Description: Tray 1 Unknown Paper Size One of the following errors was detected. • During Copy Job and Diag Job, Tray 1 was selected but the paper guides in Tray 1 are in a configuration that is not supported by the System. • During Copy Job and Diag Job, Tray 1 was selected but it has been pulled out.
Remedy: Press [Stop] on the UI Panel and either install Tray 1 or check the position of the paper guides and load the correct paper. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings. If the problem persists, check the following: • The Tray 1 paper guide mechanism for damage and foreign substances. • The Tray 1 Paper Size Switch for damage, improper installation, and Actuator operation failure. • Tray 1 Paper Size Switch: Analog Monitor [072-050]/Input Check [072-114] (PL 9.1) • The connection between the Tray 1 Paper Size Switch J109 and the ESS/MCU PWB J412 for open circuit, short circuit, and poor contact. If no problems are found, replace the ESS/MCU PWB (PL 18.3).