Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Xerox WorkCentre 5022

Code: 003-500

Description: N-Up NG Out Of Range During 2-Up or 4-Up, the reduce/enlarge ration was not within the range of 25 to 400%.
Remedy: Press [Stop] on the UI Panel and change the settings.

Code: 003-754

Description: IPS Overrun The IPS processing has overtook the Scan processing.
Remedy: This might be avoided by setting the R/E ratio to 99% or 101%. If this occurs frequently, obtain the document from the User and contact the Support Department for assistance.

Code: 003-795

Description: AMS NG Out Of Range When [Reduce/Enlarge] is set to [Auto], the reduce/enlarge ratio was not within the range of 50 to 200%.
Remedy: Press [Stop] on the UI Panel and change the settings. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings.

Code: 003-942

Description: Not-Supported Doc Size During DADF Scan of a Copy, Scan and Fax sending Job, an unsupported document size was detected.
Remedy: 1. Press [Stop] on the UI Panel. 2. Check the setting of the document size group. 3. Check whether the document size is a supported size. 4. If the document size is a supported size, the DADF might have malfunctioned. Refer to following FIP to check the DADF. • 005-196 (Size Mismatch Jam on No Mix-size) • 005-948 (SS-Size Mismatch Jam on No Mix-size)

Code: 003-956

Description: Not-Supported Doc Size During Platen Scan, an unsupported document size was detected.
Remedy: Press [Stop] on the UI Panel and change the document. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the document.

Code: 003-963

Description: APS NG Out Of Range During Copy Job, when APS is selected, the image size obtained from document size x reduce/enlarge ratio was detected to be larger than the largest Standard Paper Size.
Remedy: Press [Stop] on the UI Panel and change the settings.

Code: 003-972

Description: 1Job Max Page Over During Copy Job or Scan Job, the number of pages that can be scanned has been exceeded.
Remedy: Press [Stop] on the UI Panel and reduce the number of document pages.

Code: 003-973

Description: Auto Rotation NG Out Of Range During Copy Job, the following conditions were met. • Rotation is required. • The length of the image obtained by document x reduce/enlarge ratio is longer than 297 mm.
Remedy: Press [Stop] on the UI Panel and change the reduce/enlarge ratio.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie