Description: Tray 2 Unknown Paper Size One of the following errors was detected. • During Copy Job and Diag Job, Tray 2 was selected but the paper guides in Tray 2 are in a configuration that is not supported by the System. • During Copy Job and Diag Job, Tray 2 was selected but it has been pulled out.
Remedy: Press [Stop] on the UI Panel and either install Tray 2 or check the position of the paper guides and load the correct paper. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings. If the problem persists, check the following: • The Tray 2 paper guide mechanism for damage and foreign substances. • The Tray 2 Paper Size Switch for damage, improper installation, and Actuator operation failure. • Tray 2 Paper Size Switch: Analog Monitor [072-051]/Input Check [072-107] (PL 10.1) • The connection between the Tray 2 Paper Size Switch J820C and the STM PWB J548C for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • STM PWB (PL 10.6) • ESS/MCU PWB (PL 18.3)