Description: Tray 3 No Paper One of the following errors was detected. However, this is not detected until the paper is about to be fed. • During Copy Job or Print Job, Tray 3 was selected but Tray 3 has run out of paper and the ATS function for Tray 3 is disabled. This also includes the cases where Tray 3 was selected by the System Controller due to APS result. • During Copy Job or Print Job, Tray 3 was selected by the System due to APS result but it was detected that Tray 3 has run out of paper and the machine is unable to ATS to other Trays.
Remedy: Perform any of the following: • Press [Stop] on the UI Panel. • Load paper into Tray 3. • If this had occurred during ATS, load paper with the same settings as for Tray 3 into other than MSI. If the problem persists, check the following: • The Tray 3 paper supply mechanism for damage and foreign substances. • The Tray 3 No Paper Sensor for contamination, improper installation, and Actuator operation failure. • Tray 3 No Paper Sensor: Input Check [072-102] (PL 11.3) • The connection between the Tray 3 No Paper Sensor J102B and the 2TM PWB J549 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • 2TM PWB (PL 11.6) • ESS/MCU PWB (PL 18.3)