Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-953 — Xerox WorkCentre 5022

Code: 024-953

Description: Tray 4 No Paper One of the following errors was detected. However, this is not detected until the paper is about to be fed. • During Copy Job or Print Job, Tray 4 was selected but Tray 4 has run out of paper and the ATS function for Tray 4 is disabled. This also includes the cases where Tray 4 was selected by the System Controller due to APS result. • During Copy Job or Print Job, Tray 4 was selected by the System due to APS result but it was detected that Tray 4 has run out of paper and the machine is unable to ATS to other Trays.
Remedy: Perform any of the following: • Press [Stop] on the UI Panel. • Load paper into Tray 4. • If this had occurred during ATS, load paper with the same settings as for Tray 4 into other than MSI. If the problem persists, check the following: • The Tray 4 paper supply mechanism for damage and foreign substances. • The Tray 4 No Paper Sensor for contamination, improper installation, and Actuator operation failure. • Tray 4 No Paper Sensor: Input Check [072-103] (PL 11.3) • The connection between the Tray 4 No Paper Sensor J102A and the 2TM PWB J549 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • 2TM PWB (PL 11.6) • ESS/MCU PWB (PL 18.3)

← Xem tất cả mã lỗi Xerox WorkCentre 5022

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie