Description: 2TM Type Error An unsupported 2TM was detected to be connected. NOTE: If this is already detected, it will be displayed on the UI Panel when a Job is being performed.
Remedy: 1. Turn the power OFF and ON. 2. Turn OFF the power and check the following: • The DIP Switch setting on the 2TM PWB • The connection between the 2TM PWB J541 and the STM PWB J413C for open circuit, short circuit, and poor contact • The connection between the STM PWB J541C and the ESS/MCU PWB J413 for open circuit, short circuit, and poor contact If no problems are found, replace the following parts in sequence: • 2TM PWB (PL 11.6) • STM PWB (PL 10.6) • ESS/MCU PWB (PL 18.3)