Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-318 — Xerox WorkCentre 5225

Code: 010-318

Description: Hot-Sagging Recovery Failure RAP The Rear Thermistor detected that the machine does not recover from Hot-Sagging in time.
Remedy: Check for paper on the Fuser. The Fuser has no paper wrapped round it. Y↓N→Remove the paper. Check the installation of the Fuser Unit. The Fuser Unit is securely installed. Y↓N→Install the Fuser Unit securely. Close the LH Cover and the Front Cover. Execute Component Control[071-036 Main Motor ON]. The Main Motor can be heard. Y↓N→Go to the OF 3 (MAIN DRIVE ASSY RAP). Check the resistance of the Rear Thermistor between J600-2 and J600-4. The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 5.1). Check the wire between P/J410 and J600 for an open circuit or a short circuit. The wire between J410 and J600 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Fuser Unit (PL 5.1). If the problem persists, replace the Power Unit (PL 9.1). If the problem persists, replace the MCU PWB (PL 9.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie