Description: Rear Tamper Home Sensor Off Failure RAP After the Rear Tamper started moving away from the home position, the Rear Tamper Home Sensor did not turn Off within the specified time.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓N→Replace the parts that are interfering with operation. Execute Component Control[012-221 Rear Tamper Home Sensor]. Actuate the Rear Tamper Home Sensor with paper. The display changes. Y↓N→Check the connections of J8882 and J8984. J8882 and J8984 are connected correctly. Y↓N→Connect J8882 and J8984. Check the wire between J8882 and J8984 for an open circuit or a short circuit. The wire between J8882 and J8984 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8984-9 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8984-8 (+) and GND (-). Actuate the Rear Tamper Home Sensor with paper. The voltage changes. Y↓N→Replace the Rear Tamper Home Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control[012-026 Rear Tamper Motor FRONT ON] and Component Control[012-029 Rear Tamper Motor REAR ON]. The Rear Tamper Motor starts up. Y↓N→Check the connections of P/J8883 and J8984. P/J8883 and J8984 are connected correctly. Y↓N→Connect P/J8883 and J8984. Check the wire between J8883 and J8984 for an open circuit or a short circuit. The wire between J8883 and J8984 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the resistance of the Front Tamper Motor between J8984-19 and each point of J8984-1/3/4/6. The resistance is approx. 750Ohm. Y↓N→Replace the Front Tamper Motor (PL 23.12). Measure the voltage between the Finisher PWB J8984-19 and each point of J8984-1/3/4/ 6. The voltage is approx. +24VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Front Tamper Motor (PL 23.12). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).