Code: 012-268
Description: Booklet Rear Stapler Fail Booklet Stapler Assembly (Rear), cannot clinch properly; Booklet Rear Staple Home Switch detected not to turn on (return to Home position could not be completed) within designated time period after starting reverse motion.
Remedy: Execute Component Control[012-026 Rear Staple Motor (FWD) and 012-027 Rear Staple Motor (REV)] alternately. The motor energizes. Y↓N→Check the connections of P/J8895, P/J8893 and P/J8995. P/J8895, P/J8893 and P/ J8995 are connected correctly. Y↓N→Connect P/J8895, P/J8893 and P/J8995. Check the wire between J8895 and J8995 for an open circuit or a short circuit. The wire between J8895 and J8995 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Booklet PWB of each P8995-8/9/10/11 (+) and GND (-). The voltage is approx. +24VDC. Y↓N→Replace the Booklet PWB (PL 23.21). Replace the Finisher PWB (PL 23.16). Select Stop. Select [013-142 Rear Staple Home Switch] Select Start. Actuate the Rear Staple Home Switch. The display changes. Y↓N→Check the connections of P/J8895, P/J8893 and P/J8995. P/J8895, P/J8893 and P/ J8995 are connected correctly. Y↓N→Connect P/J8895, P/J8893 and P/J8995. Check the wire between J8895 and J8995 for an open circuit or a short circuit. The wire between J8895 and J8995 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Booklet PWB P8995-12 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Booklet PWB (PL 23.21). Replace the Finisher PWB (PL 23.16). Select Stop. If the problem continues, replace the Finisher PWB (PL 23.16).