Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-291 — Xerox WorkCentre 5225

Code: 012-291

Description: Stapler Failure RAP • After the Stapler Motor turned On (Forward rotation), the system did not detect that the Staple Head Home Sensor switched from Off to On within the specified time. • After the Stapler Motor turned On (Reverse rotation), the Staple Head Home Sensor did not turn On within the specified time.
Remedy: Execute Component Control[012-024 Front Staple Motor (FWD) and 012-025 Front Staple Motor (REV) or 012-026 Rear Staple Motor (FWD) and 012-027 Rear Staple Motor (REV)] alternately. The motor energizes. Y↓N→Check the connections of (Front Stapler Motor J8894, P/J8893 and P/J8995) or (Rear Stapler Motor P/J8895, P/J8893 and P/J8995). Connectors are connected correctly. Y↓N→Connect J8894, P/J8893 and P/J8995) or (Rear Stapler Motor P/J8895, P/J8893 and P/J8995) Check the wire between J8894, J8895 and J8995 for an open circuit or a short circuit. The wire between J8894, J8895 and J8995 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Booklet PWB of each P8894, P8995-8/9/10/11 (+) and GND (-). The voltage is approx. +24VDC. Y↓N→Replace the Booklet PWB (PL 23.21). Replace the Finisher PWB (PL 23.16). Select Stop. Select [013-141 Front Staple Home Switch or 013-142 Rear Staple Home Switch] Select Start. Actuate the Front/Rear Staple Home Switch. The display changes. Y↓N→Check the connections of (Front Staple Home Switch J8894, P/J8893 and P/J8995) or (Rear Staple Home Switch P/J8895, P/J8893 and P/J8995). Connectors are connected correctly. Y↓N→Connect (Front Staple Home Switch J8894, P/J8893 and P/J8995) or (Rear Staple Home Switch P/J8895, P/J8893 and P/J8995) Check the wire between J8894, J8895 and J8995 for an open circuit or a short circuit. The wire between J8894, J8895 and J8995 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Booklet PWB P8894-5, P8895-12 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Booklet PWB (PL 23.21). Replace the Finisher PWB (PL 23.16). Select Stop. If the problem continues, replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie