Description: Tray 2 size mismatch RAP After feeding from Tray 2, the lengths detected by the Registration Sensor and the Tray 2 Size Switch did not match.
Remedy: Check for foreign substances, distortion and paper powder in the paper transport path. No distortion, foreign substances, or paper powder are found in the paper transport path. Y↓N→Clear away the foreign substances and paper powder. Correct the distortion. Feed paper from another tray. The problem occurs when paper is fed from another tray. Y↓N→Check the guide. The guide is set correctly. Y↓N→Set the guide correctly. Check the operation of the Guide Actuator. The Guide Actuator works. Y↓N→Set the guide correctly. Check the installation of the Tray 2 Paper Size Switch. The Tray 2 Paper Size Switch is installed correctly. Y↓N→Install the Tray 2 Paper Size Switch (PL 2.1) correctly. Go to the Tray 2 Paper Size Switch and check the connectors.. Execute Component Control[089-100 Registration Sensor]. Manually activate the actuator of the Registration Sensor (PL 2.4). The display changes. Y↓N→Check the connection of P/J104. P/J104 is connected correctly. Y↓N→Connect P/J104. Check the wire between J104 and J403 for an open circuit or a short circuit. The wire between J104 and J403 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P403B-13 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P403B-8 (+) and GND (-). Actuate the Registration Sensor with paper. The voltage changes. Y↓N→Replace the Registration Sensor (PL 2.4). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).