Description: Tray 1 Empty RAP Tray 1 has run out of paper.
Remedy: Check the installation of the Tray 1 No Paper Sensor (PL 2.3) and the operation of the actuator. The Tray 1 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 1 Level Sensor. Execute Component Control[071-201 Tray 1 No Paper Sensor]. Manually activate the Tray 1 No Paper Sensor (PL 2.3). The display changes. Y↓N→Check the connections of P/J101, P/J601 and P/J409. P/J101, P/J601 and P/J409 are connected correctly. Y↓N→Connect P/J101, P/J601 and P/J409. Check the wire between J101 and J409 for an open circuit or a short circuit. The wire between J101 and J409 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P409A-10 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P409B-12 (+) and GND (-). Activate the actuator of the Tray 1 No Paper Sensor (PL 2.3). The voltage changes. Y↓N→Replace the Tray 1 No Paper Sensor (PL 2.3). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).