Description: Tray 2 Empty RAP Tray 2 has run out of paper.
Remedy: Check the installation of the Tray 2 No Paper Sensor (PL 2.3) and the operation of the actuator. The Tray 2 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 2 Level Sensor. Execute Component Control [071-202 Tray 2 No Paper Sensor]. Manually activate the Tray 2 No Paper Sensor (PL 12.3). The display changes. Y↓N→Check the connections of P/J103, P/J602 and P/J409. P/J103, P/J602 and P/J409 are connected correctly. Y↓N→Connect P/J103, P/J602 and P/J409. Check the wire between J103 and J409 for an open circuit or a short circuit. The wire between J103 and J409 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P409B-10 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P409B-12 (+) and GND (-). Activate the actuator of the Tray 2 No Paper Sensor (PL 2.3). The voltage changes. Y↓N→Replace the Tray 2 No Paper Sensor (PL 2.3). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).