Description: Tray 3 Empty RAP Tray 3 has run out of paper.
Remedy: Check the installation of the Tray 3 No Paper Sensor (PL 12.3/PL 13.6) and the operation of the actuator. The Tray 3 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 3 Level Sensor. Execute Component Control[071-203 Tray 3 No Paper Sensor]. Manually activate the Tray 3 No Paper Sensor (PL 12.3/PL 13.6). The display changes. Y↓N→Check the connections of P/J102B, P/J661B and P/J549. P/J102B, P/J661B and P/ J549 are connected correctly. Y↓N→Connect P/J102B, P/J661B and P/J549. Check the wire between J102B and J549 for an open circuit or a short circuit. The wire between J102B and J549 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Tray Module PWB P549-B10 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Tray Module PWB (PL 12.6/PL 13.8). Measure the voltage between the Tray Module PWB P549-B12 (+) and GND (-). Activate the actuator of the Tray 3 No Paper Sensor (PL 12.3/PL 13.6). The voltage changes. Y↓N→Replace the Tray 3 No Paper Sensor (PL 12.3/PL 13.6). Replace the Tray Module PWB (PL 12.6/PL 13.8). Replace the Tray Module PWB (PL 12.6/PL 13.8).