Description: MPT Empty RAP The MPT has run out of paper.
Remedy: Check the installation of the MPT No Paper Sensor (PL 7.1) and the operation of the actuator. The MPT No Paper Sensor is installed correctly and the actuator works. Y↓N→Reinstall the MPT No Paper Sensor. Execute Component Control[071-205 MPT No Paper Sensor]. Manually activate the MPT No Paper Sensor (PL 7.1). The display changes. Y↓N→Check the connections of P/J108, P/J605 and P/J411. P/J108, P/J605 and P/J411 are connected correctly. Y↓N→Connect P/J108, P/J605 and P/J411. Check the wire between J108 and J411 for an open circuit or a short circuit. The wire between J108 and J411 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P411-6 (+) and GND (-). The voltage is approximately. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P411-8 (+) and GND (-). Activate the actuator of the MPT No Paper Sensor (PL 7.1). The voltage changes. Y↓N→Replace the MPT No Paper Sensor (PL 7.1). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).