Description: (A-Finisher) Stapler Feed Ready Fail • In the operation of getting the Stapler head ready at initialization, Stapler Ready Sensor ON was not detected until a specified number (13) of Head idle-stapling operations. • Immediately before stapling, the Stapler Ready Sensor was Off.
Remedy: Enter Component Control [012-243]. Remove and reinstall the Cartridge from/in the Staple Assembly. The display changes. Y↓N→Check the connections of P/J8701 and P/J8731. P/J8701 and P/J8731 are securely connected. Y↓N→Connect P/J8701 and P/J8731 securely. Check for an open or short circuit between J8701 and J8731. The wires between J8701 and J8731 are OK. Y↓N→Repair the open or short circuit. Measure the voltage between J8701-4 (+) on the Finisher PWB and GND (-). The voltage is approx. +5VDC. Y↓N→Go to Wirenet A-Finisher +5VDC and check the +5VDC circuit. Measure the voltage between J8701-6 (+) on the Finisher PWB and GND (-). Remove and reinstall the Cartridge from/in the Staple Assembly. The voltage changes. Y↓N→Replace the Staple Assembly (PL 22.4). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7).