Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-979 — Xerox WorkCentre 5225

Code: 024-979

Description: (A-Finisher) Stapler Near Empty One of the following: • At Power On, Low Staple Sensor ON was detected. • Immediately before the start of the operation of closing the Stapler Head, Low Staple Sensor ON was detected.
Remedy: Check what amount of staples remain in the Cartridge. The is enough staples remaining run the stapler. Y↓N→Replace the Cartridge. Run DC330[012-242]. Enter Component Control [012-252]. Remove and reinstall the Cartridge from/in the Staple Assembly. The display changes. Y↓N→Check the connections of P/J8701 and P/J8731. P/J8701 and P/J8731 are securely connected. Y↓N→Connect P/J8701 and P/J8731 securely. Check for an open or short circuit between J8701 and J8731. The wires between J8701 and J8731 are OK. Y↓N→Repair the open or short circuit. Measure the voltage between J8701-4 (+) on the Finisher PWB and GND (-). The voltage is approx. +5VDC. Y↓N→Go to Wirenet A-Finisher +5VDC and check the +5VDC circuit. Measure the voltage between J8701-7 (+) on the Finisher PWB and GND (-). Remove and reinstall the Cartridge from/in the Staple Assembly. The voltage changes. Y↓N→Replace the Staple Assembly (PL 22.4). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie