Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-979 — Xerox WorkCentre 5225

Code: 024-979

Description: Stapler Near Empty RAP • The Staple Pin is nearly empty. • The cartridge has not been installed.
Remedy: Execute Component Control[012-242 Low Staple Sensor]. Install and remove the Staple Pin Cartridge. The display changes. Y↓N→Check the Staple Pin Cartridge for failure or foreign substances. There are no foreign substances and nothing has failed. Y↓N→Repair the failure and remove the foreign substances. Check the connections of J8886 and P/J8981. J8886 and P/J8981 are connected correctly. Y↓N→Connect J8886 and P/J8981. Check the wire between J8886 and J8981 for an open circuit or a short circuit. The wire between J8886 and J8981 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8981-4 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8981-6 (+) and GND (-). Install and remove the Staple Pin Cartridge. The voltage changes. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Staple Assembly (PL 23.8). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16). If the problem persists, replace the MCU PWB (PL 9.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie