Code: 024-989
Description: Booklet Low Staple R Booklet Stapler Low Staple Rear signal was detected just before Stapling operation. Booklet Stapler Low Staple Rear signal was detected at Power ON, at initialization, or when the interlock was closed.
Remedy: Supply the staples. The problem is resolved. Y↓N→Enter Component Control [013-108 Rear Low Staple Switch]. Select Start. ‘LOW’ (staples available) is displayed Y↓N→Check the connections of J8894, P/J8995 and P/J8892. The connectors are connected correctly. Y↓N→Connect the connectors. Check the wire between J8895 and J8995 for an open circuit or a short circuit. The wire between J8895 and J8995 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8995-14 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8895-1 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Rear Low Staple Switch (PL 23.20). Replace the Finisher PWB (PL 23.16). Select Stop. Replace the Finisher PWB (PL 23.16). If the problem continues, replace the Booklet PWB (PL 23.21). If the problem continues, replace the Finisher PWB (PL 23.16). If the problem persists, replace the Booklet PWB (PL 23.21).