Code: 071-210
Description: Tray 1 Lift Up Failure RAP After the Tray 1 Feed/Lift Motor turned On, the Tray 1 Level Sensor did not turn On within the specified time.
Remedy: Remove the tray and reinstall. The Tray 1 Feed/Lift Motor can be heard. Y↓N→Execute Component Control[071-007 Tray 1 Feed/Lift Motor ON]. The Tray 1 Feed/Lift Motor (PL 2.3) can be heard. Y↓N→Check the connections of P/J201, P/J601 and P/J409. P/J201, P/J601 and P/ J409 are connected correctly. Y↓N→Connect P/J201, P/J601 and P/J409. Remove the Tray 1 Feed/Lift Motor (PL 2.3) and the Tray 2 Feed/Lift Motor (PL 2.3). Replace the Tray 1 Feed/Lift Motor with the Tray 2 Feed/Lift Motor. Execute Component Control[071-007 Tray 1 Feed/Lift Motor ON]. The Tray 2 Feed/ Lift Motor (PL 2.3) can be heard. Y↓N→Return the Tray 2 Feed/Lift Motor to its original position. Check the wire between J201 and J409 for an open circuit or a short circuit. The wire between J201 and J409 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the MCU PWB (PL 9.1). Return the Tray 2 Feed/Lift Motor to its original position. Replace the Tray 1 Feed/Lift Motor (PL 2.3). Go to the OF 2 (SIZE SWITCH ASSY RAP). Check the installation of the Tray 1 Level Sensor (PL 2.3) and the operation of the actuator. The Tray 4 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 4 Level Sensor. Execute Component Control[071-206 Tray 1 Level Sensor]. Manually activate the Tray 1 Level Sensor (PL 2.3). The display changes. Y↓N→Check the connections of P/J100, P/J601 and P/J409. P/J100, P/J601 and P/J409 are connected correctly. Y↓N→Connect P/J100, P/J601 and P/J409. Check the wire between J100 and J409 for an open circuit or a short circuit. The wire between J100 and J409 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P409A-7 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P409A-9 (+) and GND (-). Activate the actuator of the Tray 1 Level Sensor (PL 2.3). The voltage changes. Y↓N→Replace the Tray 1 Level Sensor (PL 2.3). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).