Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-101 — Xerox WorkCentre 5225

Code: 077-101

Description: Registration Sensor Off JAM RAP After the Registration Clutch turned On, the Registration Sensor did not turn Off within the specified time.
Remedy: Check the Transport Roll for wear and paper powder. The Transport Roll is ok. Y↓N→Replace the Transport Roll. Check for foreign substances, distortion and paper powder in the paper transport path. No distortion, foreign substances, or paper powder are found in the paper transport path. Y↓N→Clear away the foreign substances and paper powder. Correct the distortion. Execute Component Control [089-100 Registration Sensor]. Manually activate the actuator of the Registration Sensor (PL 2.4). The display changes. Y↓N→Check the connection of P/J104 and P/J403. P/J104 and P/J403 are connected correctly. Y↓N→Connect P/J104 and P/J403. Check the wire between J104 and J403 for an open circuit or a short circuit. The wire between J104 and J403 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P403B-13 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P403B-8 (+) and GND (-). Actuate the Registration Sensor with paper. The voltage changes. Y↓N→Replace the Registration Sensor (PL 2.4). Replace the MCU PWB (PL 9.1). Execute Component Control [089-002 Registration Clutch ON]. The Registration Clutch (PL 2.4) can be heard. Y↓N→Check the connection of P/J215 and P/J403. P/J215 and P/J403 are connected correctly. Y↓N→Connect P/J215 and P/J403. Measure the resistance of the Registration Clutch (PL 2.4) between P215-1 and P215-2. The resistance is approx. 240Ohm. Y↓N→Replace the Registration Clutch (PL 2.4). Check the wire between J215 and J403 for an open circuit or a short circuit. The wire between J215 and J403 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie