Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-131 — Xerox WorkCentre 5225

Code: 077-131

Description: Duplex Wait Sensor On JAM RAP After the Exit 2 Motor turned On, the Duplex Sensor does not turn On within the specified time.
Remedy: Check the installation of the DUP Module. The DUP Module is installed correctly. Y↓N→Install the DUP Module correctly. Check the Transport Roll for wear and paper powder. The Transport Roll is ok. Y↓N→Replace the Transport Roll. Check for foreign substances, distortion and paper powder in the paper transport path. No distortion, foreign substances, or paper powder are found in the paper transport path. Y↓N→Clear away the foreign substances and paper powder. Correct the distortion. Execute Component Control [071-105 Duplex Sensor]. Actuate the Duplex Sensor (PL 8.1) with paper. The display changes to L. Y↓N→Check the wire between P/J123 and P/J541 for an open circuit or a short circuit. The wire between J123 and J541 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Duplex Sensor (PL 8.1). If the problem persists, replace the Duplex PWB (PL 8.1). Execute Component Control [073-016 Duplex Motor ON]. The Duplex Motor (PL 8.1) can be heard. Y↓N→Check the wire between P/J212 and P/J542 for an open circuit or a short circuit. The wire between J212 and J542 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Duplex Motor (PL 8.1). If the problem persists, replace the Duplex PWB (PL 8.1). Execute Component Control [047-023 Exit 2 Motor ON]. The Exit 2 Motor (PL 6.4) can be heard. Y↓N→Check the wire between P/J208 and P/J433 for an open circuit or a short circuit. The wire between J208 and J433 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the resistance of the Exit 2 Motor (PL 6.4) between J208-1 (COM) and each point of J208-2/3/4/5. The resistance is approx. 10Ohm. Y↓N→Replace the Exit 2 Motor (PL 6.4). Replace the Exit 2 Motor (PL 6.4). If the problem persists, replace the Exit PWB (PL 9.1). Replace the Duplex PWB (PL 8.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie