Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-211 — Xerox WorkCentre 5225

Code: 077-211

Description: Detected different Type Tray Module RAP A Tray Module with different specifications is connected.
Remedy: Check the settings for the DIP SW on the Tray Module PWB. The specifications are correct. Y↓N→Set the correct specifications. Check the connection of each MCU PWB connector. The connectors are connected correctly. Y↓N→Connect the connectors. Check the connection of each 2TM PWB or TTM PWB connector. The connectors are connected correctly. Y↓N→Connect the connectors. Turn on the power again. [077-211] reoccurs. Y↓N→End Check the wire between P/J541 and P/J413 for an open circuit or a short circuit. The wire between J541 and J413 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P413-A5 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Replace the 2TM PWB (PL 12.6/PL 13.8) or the TTM PWB (PL 12.6/PL 13.8). If the problem persists, replace the MCU PWB (PL 9.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie