Code: 077-301
Description: Left Hand Interlock Open RAP The L/H Cover Assembly is open.
Remedy: Check opening/closing of the L/H Cover Assembly. The L/H Cover Assembly can be opened/closed. Y↓N→Reinstall the L/H Cover Assembly (PL 2.6). Check the installation of the L/H Cover Interlock Switch. The L/H Cover Interlock Switch is installed correctly. Y↓N→Install the L/H Cover Interlock Switch correctly. Execute Component Control [071-300 L/H Cover Interlock Switch]. Open and close the L/H Cover Assembly. The display changes. Y↓N→Check the connections of P/J120 and P/J405. P/J120 and P/J405 are connected correctly. Y↓N→Connect P/J120 and P/J405. Check the wire between J405 and J120 for an open circuit or a short circuit. The wire between J405 and J120 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Check the conductivity of the L/H Cover Interlock Switch (PL 2.6) between J405-1 and J405-2. The wire between J405-1 and J405-2 is connecting successfully when the L/H Cover Assembly is closed, and is insulated when the cover is open. Y↓N→Replace the L/H Cover Interlock Switch (PL 2.6). Measure the voltage between the MCU PWB P405-2 (+) and GND (-). The voltage is approx. +24VDC. Y↓N→Measure the voltage between the MCU PWB P400-1 (+) and GND (-). The voltage is approx. +24VDC. Y↓N→Check the connections of P/J526 and P/J400. P/J526 and P/J400 are connected correctly. Y↓N→Connect P/J526 and P/J400. Check the wire between J526 and J400 for an open circuit or a short circuit. The wire between J526 and J400 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Check the connections of P/J521, P/J523 and P/J300, P/J301. P/J521, P/ J523 and P/J300, P/J301 are connected correctly. Y↓N→Connect P/J521, P/J523 and P/J300, P/J301. Check the wire between J521, J523 and J300, J301 for an open circuit or a short circuit. The wire between J521, J523 and J300, J301 are conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the ESS PWB P301-3 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the ESS PWB (PL 9.2). Replace the Power Unit (PL 9.1). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).