Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-101 — Xerox WorkCentre 5225

Code: 078-101

Description: HCF to Feed Out Sensor Fault RAP The Tray 2 Feed Out Sensor did not come on within the specified time after the start of feed from Tray 6 (HCF).
Remedy: Execute Component Control [071-100 Tray Feed Out Sensor]. Move the actuator of the Tray 2 Feed Out Sensor manually or with paper. The display changes. Y↓N→Go to 8.2 BSD and check the following wires for an open wire, short or poor contact: • Tray Feed Out Sensor P/J105-2 to MCU PWB P/J410-14 • Tray Feed Out Sensor P/J105-1 to Tray Module PWB P/J410-15 • Tray Feed Out Sensor P/J105-3 to Tray Module PWB P/J410-13 If OK, replace the Tray Feed Out Sensor (PL 2.5) before replacing the MCU PWB (PL 9.1). Execute Component Control [077-003 Takeaway Clutch]. There is operation noise from the Takeaway Clutch 1. Y↓N→Go to 8.2 BSD and check the Takeaway Clutch for an open. Check the following: • Takeaway Rolls 1 and 2 and 3 for dirt/paper particles/wear/a poor rotation • HCF and IOT for a poor docking • HCF Transport Belt for poor tension • HCF Transport Roll for dirt/paper particles/wear/a poor rotation • HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation • HCF Exit Roll for dirt/ paper particles/wear/a poor rotation • Drive gears for wear/breakage • If the results of the above checks are OK, replace Tray Module PWB (PL 13.8) and the MCU PWB (PL 9.1) one at a time in the order shown.

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie