Description: HCF Feed Out Sensor Fault RAP The paper transported from HCF did not turn on the Feed Out Sensor within the specified time.
Remedy: Execute Component Control [078-101 Tray 6 Feed out Sensor]. Place paper in front of the Feed Out Sensor. The display changes. Y↓N→Go to 8.9 BSD and check the following for an open wire, short or poor contact: • Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Feed Out Sensor PF67-1 to HCF PWB JF01-3 • Feed Out Sensor PF67-3 to HCF PWB JF01-1 If OK, replace the Feed Out Sensor (PL 18.7) before replacing the HCF PWB (PL 18.8). Execute Component Control [078-007 Tray 6 Takeaway Motor]. There is operation noise from the Tray 6 Takeaway Motor. Y↓N→Check the wire-wound resistance of Tray 6 Takeaway Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 8.9 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Check the HCF paper lift components and repair as required (PL 18.2, PL 18.3).