Code: 078-210
Description: HCF to Tray 1 Lift RAP The Tray 1 Level Sensor did not actuate in time after the Tray 1 Feed/Lift Motor energized.
Remedy: Execute Component Control [071-001 or 007 Tray 1 Feed/Lift Motor ON]. The Tray 1 Feed/ Lift Motor (PL 2.3) can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Check the connections of P/J201, P/J601 and P/J409. P/J201, P/J601 and P/J549 P/ J409 are connected correctly. Y↓N→Connect P/J201, P/J601 and P/J409. Remove the Tray 1 Feed/Lift Motor (PL 2.3) and the Tray 2 Feed/Lift Motor (PL 2.3). Replace the Tray 2 Feed/Lift Motor with the Tray 1 Feed/Lift Motor. Execute Component Control [072-001/002 Tray 2 Feed/Lift Motor ON]. The Tray 2 Feed/ Lift Motor can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Return the Tray 1 Feed/Lift Motor to its original position. Check the wires between P/J201 and P/J409 for an open circuit or a short circuit. The circuit between P/J201 and P/J409 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Tray Module PWB (PL 13.8). Return the Tray 1 Feed/Lift Motor to its original position. Replace the Tray 2 Feed/Lift Motor (PL 2.3). Check the installation of the Tray 1 Level Sensor (PL 2.3) and the operation of the actuator. The Tray 1 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 1 Level Sensor (PL 2.3). Execute Component Control [071-201 Tray 1 Level Sensor]. Manually activate the Tray 1 Level Sensor (PL 2.3). The display changes. Y↓N→Check the connections of P/J100, P/J601 and P/J409. P/J100, P/J601 and P/J409 are connected correctly. Y↓N→Connect P/J100, P/J601 and P/J409. Check the wires between P/J100 and P/J409 for an open circuit or a short circuit. The wires between P/J100 and P/J409 are conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P/J409-A7 (+) and P/J409-A8 (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the Tray Module PWB P/J409-A9 (+) and GND (-). Activate the actuator of the Tray 1 Level Sensor (PL 2.3). The voltage changes. Y↓N→Replace the Tray 2 Level Sensor (PL 2.3). Replace the MCU PWB (PL 9.1). Check the paper transport drives and repair as required (PL 2.3).