Description: HCF Feed Out Sensor Static Jam RAP The tray 6 Feed Out Sensor static jam.
Remedy: Execute Component Control [078-101 Tray 6 Feed Out Sensor]. Move the actuator of the Tray 6 Feed Out Sensor. The display changes. Y↓N→Go to 8.8 BSD and check the following for an open wire, short or poor contact: • Tray 6 Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Tray 6 Feed Out Sensor PF67-1 to HCF PWB PF01-3 • Tray 6 Feed Out Sensor PF67-3 to HCF PWB PF01-1 If OK, replace the Tray 6 Feed Out Sensor (PL 18.7) then the HCF PWB (PL 18.8). Execute Component Control [078-007 Tray 6 Takeaway Motor: 640mm/s]. There is operation noise from the Tray 6 Takeaway Motor. Y↓N→Check the wire-wound resistance of Pre Reg. Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 7.14 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Execute Component Control [089-002 REgistration Clutch. Registration Clutch operates Y↓N→Go to 8.7 BSD and check the Registration Clutch for an open. Check the following: • Drive gears for wear/breakage • HCF and IOT for a poor docking • HCF Transport Belt for poor tension • HCF Transport Roll for dirt/paper particles/wear/a poor rotation • HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation • HCF Exit Roll for dirt/ paper particles/wear/a poor rotation • If the results of the above checks are OK, replace HCF PWB (PL1.8).