Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-940 — Xerox WorkCentre 5225

Code: 078-940

Description: HCF Paper Misfeed RAP There is a problem with one of the following: • HCF Lift, Lift Motor • HCF Feed Motor
Remedy: Enter Component Control [078-003 or 004 Tray 6 Feed/Lift Motor ON]. The Tray 6 Feed/Lift Motor (PL 18.4) can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Check the connections of JF57 and JF06. JF57 and JF06 are connected correctly. Y↓N→Connect JF57 and JF06. Check the wire-wound resistance of Tray 6 Takeaway Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 8.9 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Execute Component Control [078-101 Tray 6 Feed Out Sensor]. Move the actuator of the Tray 6 Feed Out Sensor. The display changes. Y↓N→Go to 8.9 BSD and check the following for an open wire, short or poor contact: • Tray 6 Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Tray 6 Feed Out Sensor PF67-1 to HCF PWB PF01-3 • Tray 6 Feed Out Sensor PF67-3 to HCF PWB PF01-1 If OK, replace the Tray 6 Feed Out Sensor (PL 18.7) then the HCF PWB (PL 18.8). Check the HCF paper lift components and repair as required (PL 18.2, PL 18.3).

← Xem tất cả mã lỗi Xerox WorkCentre 5225

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie