Code: 075-100
Description: Misfeed Jam Paper jam was detected at the Main Paper Tray/Bypass Tray section of the printer.
Causes: • Feed Roller, PL22.4 • Feed Solenoid, PL6.1.10 • Registration Sensor, PL2.3.5 • Main Drive Assembly, PL6.1.2 • Registration Clutch, PL2.3.7 • Harness Assembly RKN SNS, PL2.2.25 • Harness Assembly Dispense MOT, PL6.1.7 • MCU Board, PL7.2.2
Remedy: 1 Are the Feed Roller and Separator Pad installed correctly? Does the Feed Roller rotate smoothly without causing fouling? Go to step 2. Replace the relevant part. 2 Check the connections between the MCU Board P/J12 and Registration Sensor P/J20. Are the connections secure? Go to step 3. Go to step 4. 3 Does the error persist? Go to step 4. Complete. 4 Enter diagnostic mode and run the Regi Sensor test (see page 4-11). You can also use CE Diag Tool to perform this test (see page A-9). Lift the Main Paper Tray Chute (PL3.3.3), does the number on the display change each time the Main Paper Tray Chute is lifted? Go to step 6. Go to step 5. 5 Disconnect the MCU Board P/J21 and the Registration Sensor P/J120. Check the Harness Assembly RKN SNS for continuity. Is the harness damaged? Go to step 6. Repair the harness. 6 Disconnect the MCU Board P/J12. Is the voltage across ground and P/J12-1 +3.3VDC? Replace the Registration Sensor. Replace the MCU Board. 7 Check the connections at MCU Board P/J16 and at the Main Drive Assembly P/J60. Are the connections secure? Go to step 9. Reconnect the connectors and then go to step 8. 8 Does the error persist? Go to step 9. Complete. 9 Enter diagnostic mode and run Main Motor on Full (see page 4-11). You can also use the CE Diag Tool to run this test (see page A-16). Does the Main Drive Assembly function correctly? Go to step 14. Go to step 10. 10 Is the Main Drive Assembly installed correctly? Go to step 12. Reseat the Main Drive Assembly, then go to step 11. 11 Does the error persist? Go to step 12. Complete. 12 Disconnect P/J16 from the MCU Board and P/J160 from the Main Drive Assembly. Check the continuity of the cable. Is the cable damaged? Repair the cable. Go to step 13. 13 Disconnect the MCU Board P/J16 and check that the voltages across ground at P/J16-2 and P/J16-4 are +24 VDC. Are the voltages correct? Replace the Main Drive Assembly. Replace the MCU Board. 14 Check the connector of P/J19 on the MCU Board. Is the connection secure? Go to step 16. Reconnect the connector, then go to step 15. 15 Does the error still occur when printing? Go to step 16. Complete. 16 Enter diagnostic mode and run the Feed SOLENOID test. You can also use the CE Diag Tool to run this test (see page A-16). Does the Feed Solenoid function correctly? Go to step 17. Replace the Feed Solenoid. 17 Check the connection at MCU Board P/J25. Is the connection secure? Go to step 19. Reconnect the connector and then go to step 18. 18 Does the error still occur when printing? Go to step 19. Complete. 19 Enter diagnostic mode and select Engine Diag > Motor Test > Regi Clutch. You can also use the CE Diag Tool to run this test (see page A-16). Does the Registration Clutch function correctly? Replace the MCU Board. Replace the Registration Clutch.