Remedy: 1 Check connectors P/J12 on the MCU Board and P/J120 on the Registration Sensor. Are the connections secure? Go to step 3. Secure the connectors, then go to step 2. 2 Does the error persist? Go to step 3. Complete. 3 Enter diagnostic mode and run the Regi Sensor test (see page 4-24). You can also use the CE Diag Tool to run this test (see page A-16). Lift the Main Paper Tray Chute (PL3.3.3). Does the Regi Sensor test pass? Replace the MCU Board then go to step 4. Go to step 5. 4 Does the error persist? Go to step 5. Complete. 5 Disconnect the MCU Board P/J12. Is the voltage across ground and J12-1 +3.3VDC? Replace the Registration Sensor. Replace the MCU Board.