Code: E2-0
Display: E2-0:EARLY FEED JAM
Description: There is a paper jam at the Sensor Photo:Regi. The paper actuates the Sensor Photo:Regi too early.
Remedy: 1 Inspect the following components. • Chute CST • Chute Bottom Lower • Sensor Photo:Regi • Actuator Regi • Spring Sensor Regi • Clutch Regi • Roll Regi Metal • Roll Regi Rubber • Roll Assy of the Cassette Sub-Assy • Option Feeder Assy • Gear Assy Drive • PWBA Conn • PWBA HKB26 MCU • PWBA HKB PS • Harness Assy Regi (J43-J431, J423) • Harness Assy Conn (J23-J231) Are they compatible with your printer version, correctly installed, not damaged, deformed, or contaminated? Go to step 2. Replace the problem component. 2 Is a piece of paper or foreign object actuating the Sensor Photo:Regi ? Remove the piece of paper or foreign object. Go to step 3. 3 ROLL ASSY and the CLUTCH ASSY FRICTION of the CASSETTE SUB-ASSY ANALYSIS 1. Remove the CRU . 2. Actuate the Switch Assy I/L Front . 3. Observe the paper feed from the Feeder Assy using MAIN MOTOR TEST. Is only one sheet of paper fed from the Feeder Assy? Go to step 4. Replace the Roll Assy and the Clutch Assy Friction . 4 ACTUATOR CST ANALYSIS Remove the Cassette Assy . Inspect the combination of the Actuator CST. Does the combination of the Actuator CST show the correct combination for the paper size present in the cassette? Go to step 5. Replace the loaded paper to the proper one. 5 ACTUATOR REGI ANALYSIS Does the Actuator Regi expose the sensing point of the Sensor Photo:Regi when a sheet of paper strikes the actuator, and does the Actuator Regi block the sensing point of the Sensor Photo:Regi when there is no paper striking the actuator? Go to step 6. Replace the Actuator Regi . 6 SENSOR PHOTO:REGI ANALYSIS Use SENSOR/SWITCH CHECK to check the Sensor Photo Regi. Does the Sensor Photo:Regi function correctly and increment the Sensor Check number on the screen each time you actuate it? Replace the PWBA HKB26 MCU . Go to 7.7 Sensor Photo:Regi Failure.